

- #MACBOOK AIR 13 INCH 2010 DISPLAY SCREEN REPLACEMENT CRACKED#
- #MACBOOK AIR 13 INCH 2010 DISPLAY SCREEN REPLACEMENT INSTALL#
When installing antenna cable back in place, push them into the guided path using plastic pry tool.
#MACBOOK AIR 13 INCH 2010 DISPLAY SCREEN REPLACEMENT INSTALL#
Install just one screw on each hinge but do not tighten them yet.Ĭlose the display and move it as necessary to make sure it’s seated evenly on each side of the laptop.Īfter that tighten two screws and install remaining screws securing the hinges. In order to make sure that your new display mounted correctly, do the following. Here are a couple of tips for reassembly.
#MACBOOK AIR 13 INCH 2010 DISPLAY SCREEN REPLACEMENT CRACKED#
If the screen got cracked or damaged otherwise, it’s necessary to replace the entire assembly as it shown on the following picture. In MacBook Air laptops the LCD screen is permanently glued inside the display assembly. Now we are ready for replace the damaged display with a new one. Separate the display assembly from the laptop body. Remove three more screws securing the right hinge. There is a metal bracket attached to the antenna cable. Remove three screws securing the left hinge. Open up the display and place the laptop upside down on the edge of the desk. There are six T8 screws securing display hinges. Pull the cable out of the connector by the black tab.Īfter all cables are unplugged and unrouted we ready to remove the display. RayHom A1466 Laptop Replacement Battery for MacBook Air 13 inch A1466 (Mid 2012,Mid 2013,Early 2014, Early 2015,2017) A1369(Late 2010,Mid 2011 Version) 7200mAh, fits A1496 A1405 A1377 4. Unlock the connector by lifting up the metal bracket.

Now we are going to disconnect the display screen cable. Unroute antenna cables from the guided path in the top case. Unplug antenna cables from the Wi-Fi Bluetooth card. Heating with hairdryer helps, but just go very slow. Install tips are: Go very slow peeling the screen surround off. If your MacBook fits the description this is the screen for you. This replacement is 10 Stars Expertly packaged and safely shipped. Just lifting up the left side should be enough to release the cable. My White MacBook 7,1 13-inch, Mid 2010 screen was destroyed. It’s not necessary to remove the board completely. TIP: if the cable got stuck under the MagSafe board, remove one screw securing the board and lift it up a little bit. Also, check out the list of devices this. I use tweezers to push the webcam cable plug out of the connector. OEM Apple MacBook Air 13 LCD Screen Display Assembly 2013-2017 A1466 B- Grade. Pay attention which screw goes where.ĭisconnect the MagSafe board power cable from the logic board.ĭisconnect the webcam cable. Pull the cable from the connector (yellow arrow). Unlock the connector by lifting up the locking tab at a 90 degree angle (red arrow). Separate cable from the fan and remove it.ĭisconnect cooling fan cable from the logic board.

The flex cable attached to the fan by adhesive tape. In order to unplug the flex cable, lift it up from the connector using plastic pry tool.
